Load the hinge on Six Shooter alignment plate with the
hinge pin towards the top of the door and the counter
sinks facing out. The alignment plate is magnetic and
will hold the hinge in place.
Note: For the Spring loaded Hinge Knuckle option, see
“Option: Quick Change Knuckle Assembly” on page 2-18
Caution: Be prepared for the front section
routers to move into position and begin rout-
ing, as well as the back section routers, lock
bore, and bolt drill.
Slide the Six Shooter over and position it into the H-
Block using the Ryertex guides.
1. Press the Start Sequence button to move the
Six Shooter into position and drop the
screws. The six shooter will snap into place.
2. When fully seated, press the Insert Screw
Button to attach the six screws
3. Press the Reset switch to raise the Six
Shooter out of the hinge pocket and feed a
set of six screws for the attachment of the
next hinge.
4. Repeat steps 1-3 for each Hinge.
5. Return the Six Shooter to the park (starting)
position. The machine will not run if this is
not completed.
6. When finished with Hinges, unclamp the door and jamb by either
pressing the Unclamp button on the Six Shooter or pressing the
Jamb Clamp foot pedal.
To continue, repeat from the load door section in this quick start.
If completed, shut down the machine. See “How to Power Down the 994-X” on
page 2-34 .
To Next Page
Loading...
