3
3.4 Selecting Output Settings
3-10
Basic Copy Operations Chapter 3
Stapling (with finisher DF-621 installed)
The copies are bound together with a staple in the corner.
However, the pages can be stapled only if all of the following conditions are met.
G There are between 2 and 30 pages in the document.
G If standard-size paper is used, the paper sizes must be
11 × 17 L, Legal L, Letter L, Letter C, Executive L and Executive C.
G If non-standard-size paper is used, the paper width must be between 7-1/4 in.
and 11-3/4 in.
G If non-standard-size paper is used, the paper length must be between 7-1/4 in.
and 17 in.
G Copies are printed only on plain paper.
G If the “Mixed Original” function is used, the copies must be produced with paper
of the same width.
G This machine must not be set to Interrupt mode.
G The “Image Adjustment” function on the Application screen is not used.
Stapling (with finisher DF-626 installed)
The copies are bound together with a staple. Either the “1 Staple” or the “2 Staples”
Output setting can be selected.
However, the pages can be stapled only if all of the following conditions are met.
G There are between 2 and 50 pages in the document. (However, if the document
size is larger than Legal, the document can contain no more than 25 pages.)
G If standard-size paper is used, the paper sizes must be 11 × 17 L, Legal L,
Letter L and Letter C.
G If non-standard-size paper is used, the paper width must be between 7-1/4 in.
and 11-3/4 in.
G If non-standard-size paper is used, the paper length must be between 7-1/4 in.
and 17 in.
G Copies are printed only on plain paper.
G If the “Mixed Original” function is used, the copies must be produced with paper
of the same width.
G This machine must not be set to Interrupt mode.
G The “Image Adjustment” function on the Application screen is not used.
To Next Page
Loading...
