Kyocera KM-C2230 - When the Message Remove Punch Scraps. Appears; Display in Enlarge Display Mode

11.6 When the Message “Remove Punch Scraps.” Appears
11
11-59
Touch Panel Messages Chapter 11
11.6 When the Message “Remove Punch Scraps.”
Appears
If the punch kit PH-620 is attached to finisher DF-626, the following message will
appear when the hole-punch waste container is full (If it can be emptied by the
user).
Display in Enlarge Display Mode
If the hole-punch waste container is full, appears in the screen on the touch
panel.