11.5 When the Message “Staple mode cannot be used.” Appears
11
11-53
Touch Panel Messages Chapter 11
Clearing Jammed Staples in Finisher DF-626
✎
Reference
For details on the positions of paper misfeeds, refer to “Paper Misfeed/Staple
Jam Indications” on page 11-22.
✎
Reminder!
If the message “Staple mode cannot be used.” appears, be sure to perform the
following procedure.
If the following procedure is not followed and the paper is pulled out with too
much force, the stapler unit may be damaged.
1 Slide the finisher away from the
machine.
2 Open the horizontal transport
unit cover.
3 Remove any misfed paper, and
then close the cover of the
horizontal transport unit.
To Next Page
Loading...
