10
10.2 Programming/Recalling Copy Programs
10-4
Utility Mode Operations Chapter 10
10.2 Programming/Recalling Copy Programs
Setting the “Reset Mode” Function
The settings selected when this machine is turned on (the power switch is set to “I”)
are called the default settings.
By specifying the default settings, the desired copy settings are selected when the
machine is turned on (the power switch is set to “I”).
1 Select the desired copy settings.
❍ For details, refer to the “Basic Copy Operations” on page 3-1.
2 Press the [Utility] key.
3 Touch [Store].
4 Touch [Reset Mode].
5 Touch [Current Mode].
✎
Additional
Information
If “Current Mode”
was selected, the
copy settings
selected before
Utility mode was
entered are stored
as the default settings.
6 Touch [Enter], and then touch [Enter] in the Store screen.
7 Touch [Exit].
The Basic screen appears again.
To Next Page
Loading...
