10.8 Administrator Settings
10
10-33
Utility Mode Operations Chapter 10
10.8 Administrator Settings
Setting the “Top Erase” Function
This function is used to set the amount of loss at the edge of the original. The
specified amount is erased during printing. (The default setting is “5 mm”.)
1 Press the [Utility] key.
2 Touch [Admin. Mode].
3 Using the keypad, type in the administrator code.
❍ Touch [Enter].
4 Touch [Admin. Set.].
5 Touch [Top Erase].
6 Touch the key for the
desired setting.
7 Touch [Enter].
8 Touch [Exit] in the next
three screens that
appear.
The Basic screen
appears again.
To Next Page
Loading...
