10
10.8 Administrator Settings
10-42
Utility Mode Operations Chapter 10
Setting the “Access Lock Release” Function
This function is used to allow access codes to be entered again after access has
been denied.
✎
Additional Information
If input of the administrator code is denied, turn this machine off, then on again.
1 Press the [Utility] key.
2 Touch [Admin. Mode].
3 Using the keypad, type in the administrator code.
❍ Touch [Enter].
4 Touch [Admin. Set.].
5 Touch [2/4].
6 Touch [Access Lock
Release].
7 Touch the key for the
access code that you
wish to allow input.
8 Touch [Enter].
❍ To return to the
Admin. Set. screen,
touch [Cancel].
The access lock is
canceled.
9 Touch [Exit] in the next three screens that appear.
The Basic screen appears again.
To Next Page
Loading...
