Kyocera KM-C2230

10.8 Administrator Settings
10
10-57
Utility Mode Operations Chapter 10
Removing the Lock Setting for the Hard Disk
By selecting the “HDD Lock” function when the hard disk is already locked, the
password can be changed or the lock setting for the hard disk can be removed.
Follow the procedure described below to remove the lock setting for the hard disk.
1 Press the [Utility] key.
2 Touch [Admin. Mode].
3 Using the keypad, type in the administrator code.
❍ Touch [Enter].
4 Touch [Admin. Set.].
5 Touch [3/4].
6 Touch [HDD Lock].
7 Touch [Disable].
8 Touch [Enter].
9 Using the keyboard that
appears on the screen,
type in the currently
specified password,
and then touch [Enter].
❍ If [Cancel] is
touched, the lock
setting for the hard
disk is not removed. The screen shown in step 6 appears again.