10
10.8 Administrator Settings
10-56
Utility Mode Operations Chapter 10
10 Type in the new password, and then touch [Enter].
❍ The keypad can also be used to type in the password.
❍ If [Cancel] is touched, the password is not changed. The screen shown in
step 6 appears again.
❍ To enter uppercase letters, touch [CAPS].
❍ To delete characters that have been entered, touch [Del.].
The “Retype New Password” box appears.
11 Type in the new password again, and then touch [Enter].
The message “Note: Please turn the main switch of the copier OFF/ON to
activate HDD Lock.” appears.
12 As instructed, turn the machine off, then on again. The new password is
registered.
✎
Reminder!
Be sure to keep the specified password in a safe place so that it will not be
lost.
The currently specified password will be needed when removing the lock
setting for the hard disk.
To Next Page
Loading...
