Kyocera KM-C2230

xii
11.4 When the Message “Misfeed detected.” Appears ................. 11-20
Locations of Paper Misfeeds.................................................. 11-20
Locations of Paper Misfeeds in the Enlarge Display Mode.... 11-21
Paper Misfeed/Staple Jam Indications................................... 11-22
Clearing a Paper Misfeed in the Bypass Tray........................ 11-23
Clearing a Paper Misfeed in the Automatic Duplex Unit ........ 11-25
Clearing a Paper Misfeed in the 1st or 2nd Drawer ............... 11-26
Clearing a Paper Misfeed in a Paper Drawer
(3rd or 4th Drawer)................................................................. 11-27
Clearing a Paper Misfeed in the Large-Capacity Paper Feed
Cabinet................................................................................... 11-28
Clearing a Paper Misfeed in the Right-Side Door .................. 11-29
Clearing a Paper Misfeed in the Fusing Unit ......................... 11-33
Clearing a Paper Misfeed in the Reverse Automatic
Document Feeder .................................................................. 11-37
Clearing a Paper Misfeed in Finisher DF-621........................ 11-41
Clearing a Paper Misfeed in Finisher DF-626........................ 11-46
11.5 When the Message “Staple mode cannot be used.”
Appears ..................................................................................... 11-50
Clearing Jammed Staples in Finisher DF-621 ....................... 11-50
Clearing Jammed Staples in Finisher DF-626 ....................... 11-53
11.6 When the Message “Remove Punch Scraps.” Appears ....... 11-59
Display in Enlarge Display Mode ........................................... 11-59
Emptying the Hole-Punch Waste Container .......................... 11-60
11.7 When the Inspection Mark “” Appears............................ 11-62
Display in Enlarge Display Mode ........................................... 11-63
11.8 When the Message “Malfunction detected.” Appears .......... 11-64
Display in Enlarge Display Mode ........................................... 11-64
11.9 When “The following units need to be replaced soon.”
Appears ..................................................................................... 11-66
Display in Enlarge Display Mode ........................................... 11-66
11.10 When the Message “Please replace XXXX.” Appears........... 11-68
Display in Enlarge Display Mode ........................................... 11-68
11.11 Main Messages and Their Remedies ...................................... 11-70
12 Troubleshooting
12.1 When the Print Quality Is Low................................................... 12-2
12.2 When the Machine Is Not Operating Correctly ........................ 12-5