10
10.10 Specifying Expert User Mode Functions
10-72
Utility Mode Operations Chapter 10
9 If horizontal lines A and B are
angled as shown at the right, touch
to specify the desired
positive adjustment for θ (between
+1 dot and +10 dots).
10 Press the [Start] key.
The adjusted test pattern is printed on 11 × 17-size paper.
11 Check the print result.
❍ If horizontal lines A and B are aligned, continue with step 12.
❍ If more adjustment is necessary, return to step 8 and repeat the adjustment
procedure.
12 Touch [Enter].
The Expert User Mode screen appears again.
13 Touch [Exit] in the next three screen that appear.
The Basic Screen appears again.
A
B
To Next Page
Loading...
