Leibinger JET3 Series - Hydraulik Settings; Figure 60 Hydraulic Settings

Page 146 Job Editor Group 8
Release 2.02 JET3 Series
7.3.2 Hydraulik settings
Figure
60
Hydraulic settings
1 – Drop-down menu <Settings>
9 – Input field <Oscillator Voltage [V]>
2 – Option <Hydraulic settings>
10 – Input field <Ink number>
3 – Dialog box <Hydraulic settings>
11 – Input field <Solvent number>
4 – Input field <Pressure [mbar]>
12 – Input field <Frequency [kHz]>
5 – Input field <Suction pump [%]>
13 – Indicators for current values
6 – Input field <Visco correction>
14 – Spin buttons for settings
7 – Input field <Fall time [msec]>
15 – Drop-down list <Ink number>
8 – Input field <Nozzle [µ]> size
16 – Drop-down list <Frequencies>
Warning
All settings in the <Hydraulic> menu have a direct impact on the functionality
of the printer!
Wrong or inappropriate settings may cause the printer to stop the work
and /or may lead to hardware damages!
All values were set at factory for an optimal operation. Changes must only be
carried out by LEIBINGER service technicians or staff trained by LEIBINGER
service technicians.
1
2
4
6
5
3
7
8
9
12
10
11
14
13
15
16