Leibinger JET3 Series - Object Settings; Figure 126 - Job Editor (Object Setting Menu)

Page 242 Job Editor Group 8
Release 2.02 JET3 Series
8.4 Object settings
The <Object Settings> dialog box provides the seetings for the object properties of the
currently selected object. The available settings and parameters are grouped tabs and
depend on the kind of object selected.
Please see chapter 8.2.3 Object creation tools about the details of object creation.
If an new object is created with one of the object creation tools the <Object settings>
dialog box opens automatically.
Most of the settings provide small icons that show the outcome of the respective setting.
Additionally there is a preview area that shows the effects of the settings on the object
selected.
Figure
126
Object setting dialog box
1 – <Global settings> tab
9 – <Orientation> and <Mirroring>
2 – Tab bar <Object settings>
10 – Preview with selected counter object
3 – <Contrast> spin button
11 – <Prompt field> checkbox
4 – <ICG> spin button
12 – <Counter> checkbox
5 – <Bold> spin button
13 – <Counter-ID> spin button
6 – <Inverse> checkbox
14 – <OK> button
7 – <Alternate> checkbox
15 – <Cancel> button
8 – <Proportional> checkbox
1
2
3
4
5
6
7
8
9
10
11
12
13
15
14