Leibinger JET3 Series - Printgo - Repeat; Figure 143 Printgo-Repetitions

Page 262 Job Editor Group 8
Release 2.02 JET3 Series
8.5.2.3 PrintGo - Repeat
The <PrintGo Repeat> defines the number of print repetitions that follow after a PrintGo
signal. Permitted values are 0 – 1000.
Example:
0 = no repetition (single print)
1 = one repetition (double print)
The number of repetitions currently set is shown in the input field.
A special type of the <PrintGo Repeat> parameter is the <Endless> option (2). With this
checkbox activated the printouts after a PrintGo signal will continue until a <PrintStop>
signal occurs.
Figure
143
PrintGo-repetitions
1 – Input / Display field <PrintGo-Repeat>
3 – Check box <Endless> active
2 – Check box <Endless> inactive
1
2
3