Page 78 Job Editor Group 8
Release 2.02 JET3 Series
6.5.3.2 Switching on with password protetction
Touch the dark Touch-Display (1) for at least 2 seconds.
The device turns on and the main window (3) is displayed with the message
<Initialization> (2).
After the initialization the device starts with the bleeding of the system automatically.
During the process the message <Bleeding> (4) is displayed. The bleeding takes
between 1 – 5 min. The process can be canceled by pressing the button <Cancel>
(5).
Note:
The start of the device happens in the logged-out status (no operator will be
logged on) but the job which has been used at last will be loaded automatically.
The dialog field <Current login> (6) and a keyboard field (8) pops up.
You will find further information regarding the operation with keyboard
in the chapter 6.4.2 Keyboard
Enter your password with the keyboard field.
Press the button <Enter> (9) of the keyboard field to finish the input.
Now press the button <Login> (10) to finish the login.
Now the user is logged-in and the active password level is displayed on top right of
the title bar (11).
The login can be also carried out without a password. In this case only
several basic functions of the device are available for the user.
You will find further information in the chapter 7.3.5 Password settings
and user permissions
To Next Page
Loading...
