Leibinger JET3 Series - Switch off Device; Figure 25 Switch-Off Procedure

Page 80 Job Editor Group 8
Release 2.02 JET3 Series
6.5.4 Switch off device
Figure
25
Switch-off procedure
1 – <Off> Button
4 – <No> Button
2 – Confirmation prompt
5 – <Shutdown> message box
3 – <Yes> Button
Proceeding:
 Press the button <Off> (1).
 A confirmation prompt (2), pops up.
 Confirm the shut down of the device by pressing the button <Yes> (3) or cancel the
process with the button <No> (4) ab.
 Now the device is turned off. During the shut down the message <Shutdown> (5) is
displayed.
Comment:
If the nozzle is still open during the turn-off procedure, it will be closed automatically.
INFORMATION
Turning off the device is only possible after a print stop.
After turning off you have to wait approx. 5 sec. until the device can
be turned on again.
1
2
3
4
5