Leibinger JET3 Series - Font Width - Stroke Distance; Orientation; Figure 137 Font Parameters - Font Width; Figure 138 - Font Parameters Values - Orientation of the Print Band

Group 8 Job Editor Page 257
JET3 Series Release 2.02
8.5.1.2 Font width - Stroke distance
The setting determines the print width. The print width is determined by the horizontal
drop distance of the strokes. A stroke is one vertical movement of the ink jet. The input
dimensions corresponds with the dimensions selected in the <Basic settings> menu
e.g. mm.
The value set is displayed in the respective input field.
As higher the entered value, as larger the distance between each stroke.
Figure
137
Font parameters - Font width
8.5.1.3 Orientation
There are three options available to change the orientation of the printband.
The printband can be rotatetd by 180° → checkbox (1)
The printband can be vertically mirrored → checkbox (2)
The printband can be rotated and mirrored → checkbox (1) + (2)
There is a preview window below the checkboxes in order to check the results.
ATTENTION
The settings not only have an effect on single printing objects but on
the complete print-band!
Figure
138
Font parameters - Orientation of the print band
1 – Checkbox <Orientation>
3 –Preview
2 –Check box <mirrored>
180°
180°
1
2
3