Leibinger JET3 Series - Figure 4 - Movable Underframe (Device Support); Figure 5 - Unit Fastening Possibilities

Group 5 Transport/Start up Page 37
JET3 Series Release 2.02
Figure
4
Movable base frame for printers of the JET3 Series
For this it is expedient to place the device on a device support.
The device has four fastening possibilities for secure seting up and should be screw
connected at the place of setting up.
Figure
5
Fastening posibilities
Mounting
thread:
4X M5
ATTENTION
A place of setting up with sufficient load bearing capacity and stability must be
chosen. Prior to assembly the place of setting up must be cleaned of dirt and
contamination (residue of lubricants etc.).
120
120
355