Lexmark XC4150 - Insufficient Memory Service Check

Insucient memory service check
Action Yes No
Step 1
Reset the printer, and then navigate to:
Settings > Print > Setup > Download Target > Disk
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
If applicable, install extra memory card.
If applicable, make sure that the additional memory card is properly
installed.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Check the controller board pins for damage, and replace if
necessary. See
“Controller board removal” on page 409.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Complex page service check
Action Yes No
Step 1
Reset the printer, and then navigate to:
Settings > Print > Setup > Download Target > Disk
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Enter the Diagnostics menu, and then navigate to:
Input tray quick print > Tray 1 > Single
Does the problem remain?
Go to step 4. Go to step 3.
Step 3
If applicable, install extra memory card.
If applicable, make sure that the additional memory card is properly
installed.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Check the controller board pins for damage, and replace if
necessary. See
“Controller board removal” on page 409.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
7528
Diagnostic information
176