Left flatbed cover removal
1 Remove the
flatbed.
See “Flatbed removal” on page 435.
2 Remove the two screws (A).
3 Slide down the
flatbed
cover to remove.
Flatbed removal
1 Remove the controller board shield. See “Controller board shield removal” on page 408.
2 Remove the inner controller board shield. See “Inner controller board shield removal” on page 409.
3 Remove the ADF. See “ADF removal” on page 426.
4 Remove the scanner tilt. See “Scanner tilt removal” on page 441.
7528
Repair information
435
To Next Page
Loading...
