8 Release the two tabs (C) from the mounting assembly, and then remove the sensor.
Sensor (waste toner contact) removal
1 Remove the waste toner bottle.
2 Remove the motor cover. See “Motor cover removal” on page 319.
3 Remove the scanner rear left cover. See “Scanner rear left cover removal” on page 335.
4 Remove the sensor (paper size). See “Sensor (paper size) removal” on page 366.
5 Disconnect the waste toner bottle contact cable (A) from the controller board.
6 Route the cable out of the printer, and then remove the sensor.
7528
Repair information
368
To Next Page
Loading...
