Lexmark XC4150 - Repeating Defects Check

Action Yes No
Step 2
Change the paper size and type, or adjust the size settings in the
tray.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Check the paper for texture or rough finish.
Is the paper textured or rough?
Go to step 4. Go to step 5.
Step 4
Replace the textured or rough paper with plain paper.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
Remove, and then reinstall the fuser. See
“Fuser removal” on
page 387.
Does the problem remain?
Go to step 6. The problem is
solved.
Step 6
Replace the fuser. See
“Fuser removal” on page 387.
Does the problem remain?
Go to step 7. The problem is
solved.
Step 7
Replace the LVPS. See
“LVPS removal” on page 359.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Repeating defects check
Action Yes No
Step 1
Check the printer rollers for dust or debris.
Are the rollers free of dust or debris?
Go to step 3. Go to step 2.
Step 2
Remove the dust or debris.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Measure the distance between the repeating marks.
Is the distance between the marks either 43.9 mm or 45.5 mm?
Go to step 4. Go to step 5.
7528
Diagnostic information
57