Lexmark XC4150 - Page 206

Action Yes No
Step 5
Check the cable on the motor and on the JMTR1 connector on the
controller board for proper connection.
Is the cable properly connected at both ends?
Go to step 7. Go to step 6.
Step 6
Reconnect the cable.
Does the problem remain?
Go to step 7. The problem is
solved.
Step 7
Check the cable for damage, and replace if necessary.
Does the problem remain?
Go to step 8. The problem is
solved.
Step 8
Replace the motor. See
“Motor (deskew) removal” on page
353.
Does the problem remain?
Go to step 9. The problem is
solved.
Step 9
Replace the controller board. See
“Controller board removal” on
page 409.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Motor (output) service check
Action Yes No
Step 1
Reset the printer.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check the cable on the motor (output) and on the JOUTDC
connector on the controller board for proper connection and
damage, and replace if necessary.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Reset the printer.
Does the problem remain?
Go to step 4. The problem is
solved.
7528
Diagnostic information
206