Lexmark XC4150 - Page 256

Error code Description Action
881 Failure to transmit training successfully in
V33, V29, V27 terminal modulation
schemes.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
882 Failure to transmit training successfully in
V17, V29 terminal modulation schemes.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
883 Failure to transmit training successfully in
V17, V27 terminal modulation schemes.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
884 Failure to transmit training successfully in
V29, V27 terminal modulation schemes.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
885 Failure to transmit training successfully in
V17 terminal modulation scheme.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
886 Failure to transmit training successfully in
V29 terminal modulation scheme.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
887 Failure to transmit training successfully in
V27 terminal modulation scheme.
• Select a lower “Max Speed” under
Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
888 Failure to transmit training successfully at
2400 bps in V27 terminal modulation
scheme.
• Adjust “Transmit Level”.
• Check line quality.
889 Failed to connect at the minimum speed
supported by the MFP.
• Adjust “Transmit Level”.
• Incompatible connection.
88A Failed to connect using V.34 modulation
scheme.
• Check line quality.
• Adjust to a lower modulation
scheme.
• Adjust Transmit Level Receive
Threshold values.
901 No fax tones detected from remote end.
• Verify destination phone number.
• Verify that the remote fax is
authorized to receive faxes.
7528
Diagnostic information
256