Enable edge-to-edge (printing)
This setting shifts all four margins to the physical edges of the page.
1 Enter the Diagnostics menu, and then navigate to:
Printer Setup > Enable edge‑to‑edge (printing)
2 Select a setting.
Note: This feature does not work in PPDS emulation.
Enable edge-to-edge (copy)
This setting determines whether the printer accepts the ADF or flatbed edge erase value when performing an
ADF or flatbed copy.
1 Enter the Diagnostics menu, and then navigate to:
Printer Setup > Enable edge‑to‑edge (copy)
2 Select a setting.
Processor ID
This setting indicates the ID of the processor on the controller board.
1 Enter the Diagnostics menu, and then touch Printer Setup.
2 View the processor ID.
Serial number
This setting displays a read-only value of the serial number.
1 Enter the Diagnostics menu, and then touch Printer Setup.
2 View the serial number.
Model name
This setting displays the model name of the printer.
1 Enter the Diagnostics menu, and then touch Printer Setup.
2 View the model name.
Engine setting [x]
Warning—Potential Damage: Do not change this setting without
specific
instructions from the next level of
support.
This setting allows you to select a printer engine setting. Possible values are 0–255. 0 is the default.
1 Enter the Diagnostics menu, and then navigate to:
Printer Setup > Engine setting [x]
2 Select a setting, enter a value, and then touch OK.
7528
Service menus
283
To Next Page
Loading...
