Top level
menu
Intermediate menu
Modem
Settings
• Caller ID Pattern
Note: Changing the value of this setting also changes the value of the Caller ID setting in the
Fax Settings.
• Dial Timeout
• Transmit Level
• Receive Thresh
• DTMF Low Level
• DTMF High Level
• Positive Twt Ctrl
• Negative Twt Ctrl
• ATRA EQM Bias
• V34 PreEmph Filt
• Dial Tone Thresh
• Progress Thresh
• Pulse Make Time
• Pulse Break Time
• Pulse Dial Type
• Interdigit Delay
• Enable CEQ
• V17 TX Filter
• DC Characteristic
• Impedance
• Caller ID Pattern
• Busy Tone Cycles
• Busy Tone Min On Time
• Busy Tone Max On Time
• Busy Tone Min O Time
• Busy Tone Max O Time
• Congest Tone Cycles
• Congest Tone Min On Time
• Adjust Power FSK
• Pulse Fall Time
• High Ring Impedance
Reboot
System
After this setting is selected, the control panel displays the message: About to reboot. Press
Start to reboot. Press Stop to return.
Scan SE
This setting displays the current left, top, right, and mag scanner registration values for each scanner source
(flatbed, ADF front, ADF rear).
Enter the Service Engineer (SE) menu, and then navigate to:
7528
Service menus
293
To Next Page
Loading...
