Using the Wired Remote Control LiveU LU600 User Guide
Figure 99: LU600 is Turned On and is Ready to Stream
Turning Off the Unit
To turn off the unit, long press the remote button, as follows:
• Software Reset (Recommended): Press and hold the remote button for
approximately four seconds. After the status LED starts to blink, the unit starts its
shutdown process, which can take approximately 15 seconds to complete. After the
unit shuts down, the status LED turns off.
• Hard Reset: Press and hold the remote button for approximately eight seconds.
Both the unit and the status LED immediately turn off.
Starting/Stopping Live/Store &
Forward Streaming
Starting Streaming
Short press the remote button while the unit is ready for streaming (meaning that the
remote status LED is green) to start streaming. The Live LED blinks for around five seconds
during the connecting phase. After the unit is streaming, both the status and the Live LEDs
are green.
To Next Page
Loading...
