TECHNICAL STANDARDS APPLIED
The standards applied in order to comply with the essential requirements of the
Directives 2006/95/CE "Electrical material intended to be used with certain limits of
voltage" and 2004/108/CE "Electromagnetic Compatibility" are the following ones:
• EN 50178 (1997) “Electronic equipment for use in power installations”.
•EN 61800-3 (2004) “Adjustable speed electrical power drive systems. Part 3: EMC
product standard including specific methods”
• EN 55011/A2 (2003) “Industrial, scientific and medical (ISM) radio-frequency
equipment. Radio disturbances characteristics. Limits and methods
of measurement”
•EN61000-4-2/A2 (2001) “Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 2: Electrostatic discharge
immunity test.
•EN61000-4-3/A2 (2004) “Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 3: Radiated, radiofrequency,
electromagnetic field immunity test.
•EN61000-4-4/A2 (2002) “Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 4: Electrical fast transients / burst
immunity test.
•EN61000-4-5/A1 (2001) “Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 5: Surge immunity test.
•EN61000-4-6/A1 (2001) “Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 6: Immunity to conducted
disturbances, induced by radio-frequency fields.
•CEI/TR 61000-2-1
(1990)
“Electromagnetic compatibility (EMC). Part 2: Environment.
Environment description for low-frequency conducted disturbances
and signalling in public low voltages supply systems”
• EN 61000-2-2 (2003) “Electromagnetic compatibility (EMC). Part 2: Environment.
Compatibility level for low-frequency conducted disturbances and
signalling in public low voltages supply systems”
• EN 61000-2-4 (1997) “Electromagnetic compatibility (EMC). Part 2: Environment.
Compatibility level in industrial plants for low-frequency
conducted disturbances”
•EN60146-1-1/A1 (1998) “Semiconductor convertors. General requirments and line
commutated convertors. Part 1-1: Specifications of basic
requirements”
To Next Page
Loading...
Need help?
General
