Lucent Technologies FiberReach DDM-2000 - Page 1064

363-206-305
Page 12 of 12 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Installation Safety Instructions
INSTALLATION SAFETY INSTRUCTIONS
1. Read and understand all instructions.
2. Installation and maintenance procedures must be followed and performed by trained
personnel only.
3. All DS1 interfaces should not leave the building premises unless connected to
telecommunication devices providing primary or secondary protection, as applicable.
4. For information on proper mounting instructions, consult 363-206-310,
DDM-2000
FiberReach Multiplexer Installation Manual
.
5. Never install telecommunication wiring during a lightning storm.
6. Never install telecommunication connections in wet locations.
7. Never touch uninsulated telecommunication wires or terminals unless the
telecommunication line has been disconnected at the DS1 interface.
8. Use caution when installing or modifying telecommunication lines.
SAVE THESE INSTRUCTIONS
.