Lucent Technologies FiberReach DDM-2000 - Parameters Provisionable Via Hardware Switches

363-206-305
Administration and Provisioning
Issue 3 June 2000
8-17
Selectable Parameters
8
Switch Selectable Parameters
8
Table 8-4 describes the parameters provisionable via hardware switches. Refer to
the command pages in Chapter 11, "Commands and Reports," for a complete
explanation of parameters.
Table 8-4. Parameters Provisionable via Hardware Switches
Parameter Range Pack Com-
mand
(
Note
)
Product ID MEGA STAR SYSCTL
rtrv-ne
DCC connection WBS, not WBS SYSCTL
DS1 line coding * AMI, B8ZS DS1, DS1PM, T1EXT
rtrv-t1
DS1 LBO† 5 settings (cable
dependent)
DS1, DS1PM
*
CIT can override switch settings. (Factory default is
noOverride
.)
Parameter can be set for each port.
† Parameter can be set for each circuit pack.