Lucent Technologies FiberReach DDM-2000 - DDM-2000 Fiberreach Parameters Provisionable Via the CIT

363-206-305
Administration and Provisioning
8-18
Issue 3 June 2000
CIT Selectable Parameters
8
Table 8-5 describes the parameters provisionable via the CIT. Refer to the
command pages in Chapter 11, "Commands and Reports," for a complete
explanation of parameters. Additional information on the ID parameters is
provided in the "Identifiers" section immediately following Table 8-5.
Table 8-5. DDM-2000 FiberReach Parameters Provisionable via the CIT
Parameter Range Default (Note 1) Command
(Note 2)
Date
Time
current value
current value
70-01-01
00:00:00
set-date
set-date
Target ID (system name)
CO/RT select
RNE stat
Alarm Group ID (almgrp)
AGNE
VT Uneqpd./AIS insert
20 characters
CO, RT
enabled, disabled
1 - 255
yes, no
Uneqpd., AIS
LT-DDM-2000
RT
disabled
255
no
AIS
set-ne
set-ne
set-ne
set-ne
set-ne
set-ne
CIT page length 0 (pager off), 3-150 rows 24
set-link
PM thresholds See PM Table -
set-pmthres
Alarm holdoff delay
Alarm clear delay
Power minor alarm level
0-30 sec
0-30 sec
MN, MJ
2
10
MN
set-attr-alm
set-attr-alm
set-attr-alm
OC1 degrade threshold 10
-5
to 10
-9
10
-6
set-oc1
syncmsg kbyte,sbyte,disabled kbyte
set-oc3
STS-1 path signal
degrade threshold
NSA STS-1 path AIS
alarm level
SA STS-1 path AIS
alarm level
STS-1 channel state
10
-5
to 10
-9
MN, NR
CR, NA
NMON, AUTO†
0 (disabled)
MN
MN
AUTO
set-sts1
set-sts1
set-sts1
set-state-sts1
VT1.5 path signal
degrade threshold¶
NSA VT path AIS
SA VT path AIS
VT channel state¶
10
-5
to 10
-8
MN, NR
MJ, NR
NMON, AUTO†
10
-6
(disabled)
MN
MJ
AUTO
set-vt1
set-vt1
set-vt1
set-state-vt1
See notes and footnotes at end of table.