Lucent Technologies FiberReach DDM-2000 - Set-Ne

SET-NE 5of1Page SET-NE
NAME
ElementNetworkSetset-ne:
FORMATINPUT
set-ne:tid= TID [,cort= CO/RT ][,idle= IdleChannelSignal ];
earlier)and3.1ReleaseFiberReach(For
set-ne:tid= TID [,rnestat= RneStat ][,almgrp= AlarmGroup ]
[,agne= AGNE ][,cort= CO/RT ][,idle= IdleChannelSignal ];
later)and4.0ReleaseFiberReach(For
DESCRIPTION
NOTE:
theoffunctionalitythedescribespagecommandThis set-ne command
releases.TARPFiberReachlaterand3.0ReleaseFiberReachin
aof(parameters)characteristics(NE)elementnetworkthesetscommandThis
DDM-2000.
NOTE:
thisthenshelf,aonportDCCorCITanyonenabledissecurityIf
onportsDCCorCITallforonlyusersprivilegedtoavailableiscommand
shelf.the
are:parametersinputThe
tid andupper-includemayandcharacters,20toupofstringaisTID
"%","+","-",characters:followingtheandnumbers,letters,lowercase
isvalueinitialthecommand,thisofusefirstthetoPrior"."."#",
LT-DDM-2000 The. TID theofbeginningtheatprintedbewill
OSTL1/X.25ofoperationproperForcommands.allforoutput
theinterfaces, TID NE.eachforuniquebemust
1:NOTE
theChanging TID networkthechangenotdoesname)(system
affectdoesbutNSAPthebydeterminediswhichaddress,
reporting.messageTL1proper
2:NOTE
allofTIDsdefaultthechangetorecommendedstronglyisIt
startup.systemsatsubnetworktheinNEs
FiberReachDDM-2000 2000June3Issue 11-273