Lucent Technologies FiberReach DDM-2000 - Set-T3

SET-T3 5of1Page SET-T3
NAME
CharacteristicsT3Setset-t3:
FORMATINPUT
set-t3: Address :[md= Mode ][,ais= AlarmIndicationSignal ][,alm= AlarmLevel ]
[,fth= FailureThreshold ][,pmmd= PMMode ][,frame= Frame ][,fmt= Format ];
DESCRIPTION
!
CAUTION:
service.affectmaycommandthisofExecution
ports.DS3moreoroneofparameterscharacteristicthesetscommandThis
andconditions,AISthresholds,failurelevels,alarmincludecharacteristicsThese
monitoring.performance
shelftheifONLYallowediscommandthis3.1,ReleaseFiberReachwithStarting
FunctiontheinpackscircuitDS3andMaininOLIUs28-typewithequippedis
slots.unit
equippedisshelftheifalsoallowediscommandthis4.0,ReleaseFiberReachIn
slots.unitFunctiontheinpackscircuitDS3andMaininOLIUs26/29-typewith
are:parametersinputThe
Address orOneprovisioned.betoport(s)DS3theofaddresstheisAddress
BBG19withequippedgroupsFunctionspecified.bemayportsall
theinsloteachforportsindependenthavepackscircuitDS3
functiontheforprovisionedparametershowevergroup;function
ports.bothtoappliedaregroup
BBG19):BBG4B,(BBG4,AddressesPortDS3Valid {f,all}
md signal.DS3theofmoderemovalmonitorviolationtheisMode
values:followingtheofonehavemayparameterThis
vmr value).(defaulterrorsbitPDS3removeandMonitor
vm errors.bitPDS3removenotdobutMonitor
cc bitPDS3removeormonitornotDo—channelClear
errors.
tosetisparameterthisIf vmr or vm the, ais notwillparameter
for.promptedbe
tosetisparameterthisIf cc the, pmmd, frame and, fmt
thecase,thisinAlsoused.benotwillparameters pmmd, frame,
and fmt currentThevalues.currenttheirkeepwillparameters
thewhetherusedbetoavailablebewillparametersbothforvalues
11-342 2000June3Issue FiberReachDDM-2000