Lucent Technologies FiberReach DDM-2000 - Set-State-T1

SET-STATE-T1 2of1Page SET-STATE-T1
NAME
StatePortT1Setset-state-t1:
FORMATINPUT
set-state-t1: Address :ps= PrimaryState ;
DESCRIPTION
turntousediscommandThisports.T1orDS1ofstatethesetscommandThis
port.specifiedafromfailuressignaltoduealarmtheoffandon
are:parametersinputThe
Address port(s).T1orDS1theidentifiesAddress
configuration):protected(1x1AddressesValid all,
{a,b,c,d}-{1,all}-{1-4,all}
configuration):protected(1x7AddressesValid all,
d-1-{1-4,all}{a,b,c}-{1,2,all}-{1-4,all},
portsaddressingWhenports.T12supportspackcircuitBBF6The
Specifyingvalid.are2and1numbersportonlyBBF6,aon all
only.2and1portsselects
ps followingtheofonehavemaywhichstateporttheisPrimaryState
values:
auto theatsignalgoodformonitoredbetostateSet
port.specified
nmon monitored).(notalarmed""nottostateSet
NOTE:
theinisportaIf nmon thetoreturnedbemustitstate, auto (usingstate
becanportthatwithassociatedpackscircuitanybeforecommand)this
thebylistequipmentthefromremoved upd command.
11-322 2000June3Issue FiberReachDDM-2000