Lucent Technologies FiberReach DDM-2000 - Set-Attr-Env

SET-ATTR-ENV 2of1Page SET-ATTR-ENV
NAME
EnvironmentAttributeSetset-attr-env:
FORMATINPUT
set-attr-env: Address [:alm= Alarm ][,almtype= AlarmType ][,desc= Description ];
DESCRIPTION
environmentaltheoflevelalarmthe(set)provisiontousediscommandThis
ofreportshistoryandalarmtheinentriesasappearinputsActivepoints.input
messagesTL1autonomousgenerateand(NE)elementnetworklocalthe
(GNE).elementnetworkgatewaythethrough
are:parametersinputThe
Address provisioned.betopointenvironmentaltheidentifiesAddress
parameter.thisforvaluedefaultnoisThere
Addresses:Valid env-{1-15}, env-{all}
NOTE:
addressThe env-{all} whenonlyallowedis alm theis
addressThecommand.thisforusedparameteronly env-
{all} thewhenallowednotis almtype and/or desc
used.areparameters
alm andinputenvironmentaltheoflevelalarmprovisionedtheisAlarm
values:followingthehas
cr alarmCritical
mj alarmMajor
mn (default)alarmMinor
na reported.butalarmed,Not
almtype alarm.oftypetheclassifytousedisparameterThisAlarmType.
lower-andupper-string,alphanumericanbemaydescriptionThe
valueoriginalThelong.characters10toupspaces,nowithcase
"Misc."isAlarmTypeof
desc descriptionThepoint.thefornamedescriptiveaisDescription
nowithlowercaseandupper-string,alphanumericanbemay
long.characters26toupspaces,
FiberReachDDM-2000 2000June3Issue 11-253