Lucent Technologies FiberReach DDM-2000 - Set-T1

SET-T1 5of1Page SET-T1
NAME
CharacteristicsT1Setset-t1:
FORMATINPUT
set-t1: address [:lc= LineCode ][,alm= AlarmLevel ][,fth= FailureThreshold ]
[,dlc= DLCBPVtoLOS ][,ais= AlarmIndicationSignal ][,pmmd= PMMode ]
[,fmt= Format ];
DESCRIPTION
!
CAUTION:
service.affectmaycommandthisofExecution
Theseports.T1orDS1moreoroneofparametersthesetscommandThis
AISandthresholds,failurecoding,linelevels,alarmincludecharacteristics
conditions.
NOTE:
theallwithprovisionedautomaticallyispackcircuitprotectionDS1The
theforexceptprotects,itpackservicetheasoptionsuser-settablesame
CIT).theviaprovisionednotis(whichvalue(LBO)buildoutline
are:parametersinputThe
Address provisioned.betoport(s)T1orDS1theofaddresstheisAddress
specified.bemaymoreorportOne
configurations):protected(1x1AddressesValid all,
{a,b,c,d}-1-{1-4,all}{a,b,c,d}-all,
configurations):protected(1x7AddressesValid all,
{a,b,c}-{1,2}-{1-4,all}{a,b,c,d}-all,
d-1-{1-4,all}
portsaddressingWhenports.T12supportspackcircuitBBF6The
Specifyingvalid.are2and1numbersportonlyBBF6,aon all
only.2and1portsselects
FiberReachDDM-2000 2000June3Issue 11-337