Issue 3 June 2000
11-1
11
Commands and Reports
11
Overview
11
This chapter describes the command and report features of the American
Standard Code for Information Interchange (ASCII) terminal interface to a
DDM-2000 FiberReach Multiplexer. It provides detailed information about each
command, as well as system report outputs and explanations.
Reason for Reissue
11
This chapter has been updated to provide the details of software commands for
FiberReach Release 4.0. This release features the 29G-U OC-12 OLIU circuit
pack , which provides OC-12 optics on the DDM-2000 FiberReach shelf.
FiberReach Release 4.0 offers Target ID Address Resolution Protocol (TARP),
which provides for multi-vendor interworking. For additional information on TARP,
please refer to the “About This Document” sections.
Command Page Format
11
This chapter includes DDM-2000 commands that are presented as one- or
multiple-page entires in alphabetical order. The name of each command appears
at the top of each page.
Each entry is presented in a common format:
—The NAME part gives the name of the command and summarizes its
funtion.
—The INPUT FORMAT provides the syntax for each command. Each
command starts with a command name followed by a colon. Parameters
follow the colon. Optional parameters are enclosed in square brackets [ ].
—The DESCRIPTION part provides detailed information about each
command.
To Next Page
Loading...
Need help?
General
