363-206-305
Administration and Provisioning
Issue 3 June 2000
8-19
Table 8-5. DDM-2000 FiberReach Parameters Provisionable via the CIT (Continued)
Parameter Range Default
(Note 1)
Command
(Note 2)
DS1 line coding*
DS1 alarm level*
DS1 AIS insertion*
DS1 failure threshold*
DS1 BPV to LOS*
DS1 PM Mode*
DS1 PM Format*
DS1 primary port state*
AMI,B8ZS,noOverride‡
MJ, MN, NA
yes, no
10
-3
, 10
-6
yes, no
off,on
sf, esf, esfn
NMON, AUTO‡
noOverride
NA
yes
10
-3
no
off
esf
AUTO
set-tl*
set-tl*
set-tl*
set-tl*
set-tl*
set-tl*
set-tl*
set-state-tl*
Environmental alarm level
Environmental alarm type
Environmental alarm
description
Control point description
CR, MJ, MN, NA
10 characters
26 characters
26 characters
MN
set-attr-env
set-attr-env
set-attr-env
set-attr-cont
Far end communication over
DCC §
DCC identity for OSI subnetwoks
enabled, disabled
userside, networkside
enabled
see command page
set-fecom
set-fecom
Set security §
CIT security §
CIT timeout (minutes) §
DCC security §
DCC timeout (minutes) §
CIT port type §
CIT TL1 baudrate §
CIT TL1 echo §
X25 asynch baudrate §
X25 asynch echo §
enabled,disabled,lockout
enabled,disabled,lockout
0-120
enabled,disabled,lockout
0-120
CIT, TL1
1200, 2400, 4800, 9600, 19200
enabled, disabled
1200, 2400, 4800, 9600, 19200
enabled, disabled
disabled
disabled
15
disabled
15
CIT
9600
enabled
9600
enabled
set-secu
set-secu
set-secu
set-secu
set-secu
set-secu
set-secu
set-secu
set-secu
set-secu
Sync Timing Source
SYNC mode switching
SYNC Autoreconfiguration§
main-1, main-2
revertive, nonrevertive
enabled, disabled
main-1
revertive
26-type OLIU enables
28-type OLIU disabled
set-sync
set-sync
set-sync
Feature Packaging §
VT PM or DS1 PM
enabled, disabled disabled
set-feat
NSAP
(Layer 3 provisioning)**
L3org (Organization ID)
L3res(Reserved)
L3rd (Routing Domain)
L3area(Area)
6 hex digits
4 hex digits
4 hex digits
4 hex digits
000000
0000
0000
0000
ent-ulsdcc-l3
ent-ulsdcc-l3
ent-ulsdcc-l3
ent-ulsdcc-l3
See notes and footnotes at end of table.
To Next Page
Loading...