Lucent Technologies FiberReach DDM-2000 - Page 1077

363-206-305 Acceptance:
Issue 3, June 2000 Page 1 of 2
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
IXL-001
Acceptance Task Index
FIND YOUR JOB IN THE LIST BELOW . . . . . . . . . THEN GO TO
Acceptance Procedures (Shelf Equipped)
NOTE:
The following procedures are for use in testing the DDM-2000 FiberReach
Multiplexer after another organization has equipped it. The procedures test the
DDM-2000 FiberReach shelf after all circuit packs have been installed and the
shelf is looped back or after a system has been established end-to-end. They
are not intended to be used for initial system turnup or in establishing an
end-to-end system. System Turnup procedures are found in this manual under
the System Turnup/Circuit Order tab.
Overview of Acceptance (Test) Procedures for DDM-2000
FiberReach Multiplexer (Equipped) — Wideband) . . . . . . . . Acceptance: NTP-002
Test (Accept) DDM-2000 FiberReach Multiplexer Shelf
(Looped-Back) — Wideband. . . . . . . . . . . . . . . . . . . . . . . . . Acceptance: NTP-003
Test (Accept) End-to-End DDM-2000 System
(Network) — Wideband Shelf . . . . . . . . . . . . . . . . . . . . . . . . Acceptance: NTP-004
Acceptance Procedures (Shelf Unequipped)
NOTE:
Procedures for installing and testing DDM-2000 FiberReach system
bays, shelves, and cables are found in 363-206-310, DDM-2000
FiberReach Multiplexer Installation Manual .