363-206-305 System Turnup/Circuit Order:
Issue 3, June 2000 Page 1 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
IXL-001
Task Index
System Turnup/Circuit Order
FIND YOUR JOB IN THE LIST BELOW . . . . . . . . . THEN GO TO
Equipment Required for Shelf Turnup
1. AT&T PC 6300 compatible personal computer with MS-DOS
*
Release 2.1 or
later. Used for loading software.
2. Proper software release for system configuration you have.
3. FS1E-E-02 lightguide jumpers for looping shelf OLIUs.
Initial Shelf Turnup and Establishing End-to-End System
NOTE:
These procedures are used to equip DDM-2000 FiberReach shelves,
establish end-to-end FiberReach/OC-3 or OC-12 networks, and establish
initial end-to-end DS1, T1, DS3, HDSL, and/or OC-3c service after all
necessary bay, shelf, and cable installation has been done.
Low-Speed Protection Mode — Install/Change
Install DS1 Protection Bus Module (1X1 or 1X7)
System Out-of-Service . . . . . . . . . . . . . . . . . . . . . . . Circuit Order: NTP-011
Change DS1 Protection Bus Module (1X1 or 1X7)
Low-Speed Slots Out-of-Service . . . . . . . . . . . . . . . . Circuit Order: NTP-012
Shelf — Equipping (Looped Back)
Equip DDM-2000 FiberReach Wideband Shelf
(Looped Back) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . System Turnup: NTP-007
* Registered trademark of Microsoft Corporation
To Next Page
Loading...