NTP-002
: Circuit Order 363-206-305
Page 6 of 8 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
16.
NOTE:
The rtrv-sync: command retrieves the
Synchronization Report. This report displays the
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
"Commands and Reports" section of this manual for a
description of the rtrv-sync: command format.
Use the rtrv-sync: command to obtain the
Synchronization Report and verify if Sync
Autoreconfiguration is enabled. Use the set-sync: command to
enable the Sync Autoreconfiguration parameter, if required.
17. Use the
rtrv-ne:
command at each site to verify no duplicate
TID settings exist. If duplicates exist, determine new settings and
use the
set-ne:
command to make new settings.
18.
NOTE:
FT-2000 OC-48 with Releases 8.1 through 9.1, DDM-2000
OC-3/OC-12 shelves with Release 15 and FiberReach
OC-1/OC-3/OC-12 shelves with Release 4 software support
AGNE(s) and alarm groups. WaveStar TDM 2.5G OC-48
and 10G OC-192, DDM-2000 OC-12 shelves with Release 7
or 13 and FiberReach OC-3 shelves with Release 3 software
do
not
support these features and will
not
appear in the
alarm groups of a network with mixed software.
NOTE:
The Remote NE Status (rnestat) parameter of the
set-ne: command must be enabled prior to designating
the AGNE(s) and alarm group numbers.
To Next Page
Loading...