NTP-002
: Circuit Order 363-206-305
Page 8 of 8 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
21.
NOTE:
Proper cross-connections must be made at each shelf to
establish the complete end-to-end path for the DS1/DS3 port
being tested. After one path (ring1 or ring2) has been tested,
use the sw-path-vt1/sts1: command at both ends to
test the other ring path.
Perform end-to-end single ring DS1/DS3 transmission test for the
circuits being added, as required.
DLP-510
A. Single Ring DS1 Test
DLP-511
B. Single Ring DS3 Test
22. The system is ready for service to be established.
Initial DS1 Service [
System Turnup: NTP-004
]
Initial T1 Service [
System Turnup: NTP-013
]
Initial HDSL Service [
System Turnup: NTP-017
]
Initial DS3 Service [
System Turnup: NTP-025
]
STS-3c Service [
System Turnup: NTP-016
]
To Next Page
Loading...