Lucent Technologies FiberReach DDM-2000 - Page 1204

NTP-020
: System Turnup 363-206-305
Page 6 of 14 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
14.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
The rtrv-sync: command retrieves the
Synchronization Report. This report displays the
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
"Commands and Reports" section of 363-206-295,
DDM-2000 OC-12 Multiplexer, TARP Release 7,
User/Service Manual - Volume I, 363-206-285, DDM-2000
OC-3 Multiplexer, TARP Release 13 and Later, User/Service
Manual - Volume I, and this manual, for a description of the
rtrv-sync: command format.
Use the rtrv-sync: command to obtain the
Synchronization Report and verify if Sync
Autoreconfiguration is enabled. Use the set-sync: command to
enable the Sync Autoreconfiguration parameter, if required.
15. Verify no duplicate TID settings exist. The rtrv-ne: command
may be used at each shelf in the network to display settings. If
duplicates exist, determine new settings and use the set-ne:
command to make new settings.