NTP-021
: System Turnup 363-206-305
Page 8 of 12 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
At the FiberReach shelf, use the ent-ulsdcc-l3 command to
designate the NSAPAREA field and level 2 IS-IS routing, as
required.
At the FT-2000 shelf, use the
CONFIGURATION-Set-ULSDCC-L3 command to designate the
L3 Area address and Level 2 IS parameters, as required.
DLP-514
18. Perform optical fiber connections and verification of the integrity of
the optical span being established.
19.
NOTE:
The rtrv-pm-line command in the following procedure
displays performance monitoring data associated with the
OC-3/OC-12 lines terminated on the system.
DLP-515
Perform end-to-end OC-3/OC-12 line test.
20. Repeat this procedure for all OC-3/OC-12 optical spans being
established in the FT-2000 to FiberReach OC-3/OC-12 network.
Ensure that the last optical span connected to the FT-2000 host
shelf is connected to an
OLIU
in the opposite slot as the one in
the first OC-3 span (for example, slot
1A
for the first span and slot
1B
for the second span).
21.
NOTE:
Establishing service requires that the proper slots in each
terminating node be properly equipped with the correct
circuit pack(s) for the type of service being established. It
also requires numerous cross connections in each of the
nodes representing the path of the required service.
Additionally, transmission tests should be performed to verify
the continuity and quality of the established circuit.
The single-homed FiberReach OC-3 or OC-12 access network is
now ready for initial service to be established.
Initial DS1 Service [
System Turnup: NTP-004
]
Initial T1 Service [
System Turnup: NTP-013
]
Initial HDSL Service [
System Turnup: NTP-017
]
Initial DS3 Service [
System Turnup: NTP-025
]
STS-3c Service [
System Turnup: NTP-016
]
To Next Page
Loading...