Lucent Technologies FiberReach DDM-2000 - Page 1290

NTP-030
: System Turnup 363-206-305
Page 6 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
13.
NOTE:
The Remote NE Status (rnestat) parameter of the
set-ne: command must be enabled prior to designating
the AGNE(s) and alarm group numbers.
NOTE:
Shelves may be designated as an alarm gateway network
element (AGNE) and assigned an alarm group number.
(Default alarm group number is 255.) At least one AGNE is
required per alarm group. One primary AGNE and one
backup per alarm group is recommmended. For a network
greater than 16 nodes, the AGNE and TL1 GNE should be
on separate nodes. The AGNE parameter of the set-ne:
command may have been set to yes on each new shelf
during shelf turnup procedures to suppress an AGNE
communication failure alarm.
Use the set-ne: command to designate the AGNE(s) and
alarm group numbers, as required.
14.
NOTE:
Only
one
remote FiberReach OC-3 shelf is allowed in this
linear-extension configuration.
NOTE:
This OC-3 linear extension requires that the
FUNCTION
UNITS ( ) 1 OLIU
on the host OC-3 shelf connect to the
MAIN-1 OLIU
at the FiberReach OC-3 shelf.
MAIN-2 OLIU
at the FiberReach OC-3 shelf (node) connects to
FUNCTION UNITS ( ) 2(P) OLIU
on the host OC-3 shelf.
See Figure 1. This procedure will establish the OC-3 linear
extension starting from the host OC-3 node to the
FiberReach OC-3 node and back to the host OC-3 node.
At the near end, remove the optical loop from the
OLIU
(for
example in Figure 1, Node 5 OC-3 shelf
FUNCTION UNITS A 1
)
associated with the optical span being established. At the other
end of the optical span, remove the optical loop from the
associated
28-Type OLIU
(for example, in Figure 1, Node 7
FiberReach OC-3 shelf
MAIN-1 OLIU
).