363-206-305 System Turnup:
NTP-031
Issue 3, June 2000 Page 5 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
Set timing mode on TGS/TG3 circuit packs to the timing mode
specified in work order or office records. (OC-12 Shelf Reference:
363-206-295,
DDM-2000 OC-12 Multiplexer, TARP Release 7,
User/Service Manual (TOP)—Volume II
, DLP-510 or
363-206-285,
DDM-2000 OC-3 Multiplexer, TARP Release 13 and
Later, User/Service Manual (TOP)—Volume II
, DLP-513).
10.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the OC-12
MAIN 1(MAIN-B-1) and MAIN 2(P) (MAIN-B-2(P)) optical
interfaces at any node in the OC-12 ring, it must be enabled
at all nodes in the OC-12 ring and in the FUNCTION UNITS
slots of the host OC-12 shelf. It must be enabled at the
MAIN-1 and MAIN-2 slots for the DDM-2000 FiberReach
OC-3 shelf used for the linear extension.
NOTE:
The rtrv-oc3: and rtrv-oc12: commands retrieve the
OC-3 Line Provisioning Report and
OC-12 Line Provisioning Report. This report
displays the provisioned configuration of OC-3/OC-12 lines.
See the Commands and Reports section in Volume I of this
manual and 363-206-295,
DDM-2000 OC-12 Multiplexer,
TARP Release 7, User/Service Manual—Volume I
or
363-206-285,
DDM-2000 OC-3 Multiplexer, TARP Release
13 and Later, User/Service Manual—Volume I
for a
description of the rtrv-oc3: and rtrv-oc12: command
format.
Use the rtrv-oc3: and rtrv-oc12: commands to obtain the
OC-3 Line Provisioning Report and OC-12 Line
Provisioning Report and verify if Kbyte/Sbyte is enabled.
Use the set-oc3: and set-oc12: command to enable the
Kbyte/Sbyte parameter, if required.
To Next Page
Loading...