363-206-305 System Turnup:
NTP-032
Issue 3, June 2000 Page 3 of 10
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
7. Use the rtrv-oc3/set-oc3 or rtrv-oc12/set-oc12
command at the remote DDM-2000 FiberReach shelf to verify/set
application (
dcc
) parameter for the OC-3/OC-12 MAIN slots being
used for this OC-3/OC-12 linear extension. For example,
set-oc3:main-1,dcc=
identical
and
set-oc3:main-2,dcc=
identical
or
set-oc12:main-1,dcc=
identical
and
set-oc12:main-2,dcc=
identical
.
8.
NOTE:
This procedure will establish the OC-3/OC-12 linear
extension starting from the FT-2000 host node to the
OC-3/OC-12 node, then back to the host FT-2000 node.
NOTE:
The Network Side (NS)/User Side (US) parameters of the
OC-3/OC-12 set-fecom: command and the FT-2000 DCC
orientation must be set opposite at each end of the optical
spans. For example, see Figure 2.
Use the rtrv-fecom/set-fecom command at the DDM-2000
or the CONFIGURATION-Enter-Assignment-DCC command at
the FT-2000 to verify/set Network Side/User Side parameters at
each end of all optical spans being established.
9.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
FiberReach OC-3/OC-12 MAIN-1 and MAIN-2 optical
interfaces on the OC-3/OC-12 linear extension, it must be
enabled at all nodes in the FT-2000 ring.
NOTE:
The rtrv-oc3: or rtrv-oc12:command retrieves the
OC-3 Line Provisioning Report or
OC-12 Line Provisioning Report. This report
displays the provisioned configuration of OC-3/OC-12 lines.
See the Commands and Reports section of this manual for a
description of the rtrv-oc3: or rtrv-oc12: command
format.
To Next Page
Loading...