363-206-305 System Turnup:
NTP-034
Issue 3, June 2000 Page 3 of 12
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
5. Use the rtrv-oc3/set-oc3 or rtrv-oc12/set-oc12
command at the remote FiberReach shelf to verify/set application
(
dcc
) parameter for the OC-3/OC-12 MAIN slots being used for
this OC-3/OC-12 linear extension. For example,
set-oc3:main-1,dcc=
identical
and
set-oc3:main-2,dcc=
identical
or
set-oc12:main-1,dcc=
identical
and
set-oc12:main-2,dcc=
identical
.
6.
NOTE:
This procedure will establish the FiberReach OC-3/OC-12
linear extension starting from the WaveStar TDM 2.5G/10G
host node to the OC-3/OC-12 node, then back to the host
WaveStar TDM 2.5G/10G node.
NOTE:
The Network Side (NS)/User Side (US) parameters of the
OC-3/OC-12 set-fecom: command and the WaveStar
TDM 2.5G/10G DCC orientation must be set opposite at
each end of the optical spans. For example, see Figure 2.
Use the rtrv-fecom/set-fecom command at the DDM-2000
or the Enable/Disable DCC Terminations, T 305, procedure at
the WaveStar TDM 2.5G/10G to verify/set Network Side/User
Side parameters at each end of all optical spans being
established.
7.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
FiberReach OC-3/OC-12 MAIN-1 and MAIN-2 optical
interfaces on the OC-3/OC-12 linear extension, it must be
enabled at all nodes in the WaveStar TDM 2.5G/10G ring.
NOTE:
The rtrv-oc3: or rtrv-oc12: command retrieves the
OC-3 Line Provisioning Report or
OC-12 Line Provisioning Report. This report
displays the provisioned configuration of OC-3/OC-12 lines.
See the Commands and Reports section of this manual for a
description of the rtrv-oc3: or rtrv-oc12: command
format.
To Next Page
Loading...