363-206-305 System Turnup:
NTP-034
Issue 3, June 2000 Page 7 of 12
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
14. FiberReach shelves that are part of a subnetwork being
partitioned into multiple areas require that the NSAP
AREA
field
and level 2 IS-IS routing parameters of the ent-ulsdcc-l3:
command be set. See Section 11, Commands and Reports in
363-206-305,
DDM-2000 FiberReach Multiplexer,
Wideband/Narrowband Shelf, TARP Release 3 and Later,
User/Service Manual—Volume I
, for an explanation of the
command parameters. WaveStar TDM 2.5G/10G shelves that are
part of a subnetwork being partitioned into multiple areas require
that the L3 Area Address and Level 2 IS parameters be set. See
365-371-110,
WaveStar TDM 2.5G (OC-48), Release 3.0, User
Operations Guide or
365-371-310,
WaveStar TDM 10G (OC-192),
(2 Fiber), Release 1.0, User Operations Guide
, for an explanation
of the required parameters. See 824-102-144,
Lucent
Technologies 2000 Product Family, Operations Interworking
Guide For TARP Releases
, for an explanation of the engineering
rules for subnetwork partitioning.
At the FiberReach shelf, use the ent-ulsdcc-l3: command to
designate the NSAP
AREA
field and level 2 IS-IS routing, as
required.
At the WaveStar TDM 2.5G/10G shelf, use the appropriate
menu/toolbar to designate the L3 Area address and Level 2 IS
parameters, as required.
15.
NOTE:
The rtrv-pm-line: command in the following procedure
displays performance monitoring data associated with the
OC-3/OC-12 lines terminated on the system.
DLP-515Perform end-to-end OC-3/OC-12 line test.
16. Repeat this procedure for the OC-3/OC-12 optical span being
established in the WaveStar TDM 2.5G/10G to FiberReach
OC-3/OC-12 network. Ensure that the last optical span
connected to the WaveStar TDM 2.5G/10G host shelf is
connected to an LEY15/LEY16 OC3/STM1 Port Unit or
LEY13/LEY14 OC12/STM4 Port Unit in the opposite slot as the
one in the first OC-3/OC-12 span.
To Next Page
Loading...