TAP-112
: Trouble Clearing 363-206-305
Page 2 of 16 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Figure 1 – Example of Active Alarms and Status Report
3.
NOTE:
Local alarm or status conditions have a Source Address of the local slot,
line, port, channel, path, cross-connection, or operations interface (DCC,
X.25, etc.) where the event occurred. (See
Addresses
in the Commands
and Reports section of this manual.) Use the rtrv-alm command to
get another report, if necessary.
Note the trouble indication in the Description column of the Active
Alarm and Status Report, starting with the highest alarm level
(Minor) listed in the Alarm Level column.
4. Use opr-aco command to silence active audible office alarms, if required.
5. Find the trouble description in Table A for the highest alarm level and go to the
indicated step or procedure.
*Active Alarms and Status Report
===============================================================
Alarm Source Date Time Srv Description
Level Address Detected
===============================================================
MINOR dcc-m2 MM-DD HH:MM:SS nsa section dcc channel failed
---------------------------------------------------------------
ne-acty m2-1 MM-DD HH:MM:SS - inc. STS1 yellow
ne-acty m2-2 MM-DD HH:MM:SS - inc. STS1 yellow
ne-acty main-2 MM-DD HH:MM:SS - inc. OC1 FERF
*/
To Next Page
Loading...